Filter
Top Products
ENGLISH
38
NORMAL : When the low frequency signals of channels set to "LARGE" are reproduced from those
channels only.
In this mode, the low frequency signals that are produced from the subwoofer channel
is only the low frequency signals of LFE (from the multi-channel sources that contains
LFE (Low Frequency Effects) channel, also called the ".1" channel) and the channels set to
"SMALL".
SW PLUS
: When the low frequency signals of channels set to "LARGE" are produced
simultaneously from those channels and the subwoofer channel.
In this mode, the low frequency range expands more uniformly through the room, but
depending on the size and shape of the room, interference may result in a decrease of the
actual volume of the low frequency range.
When selecting the SUBWOOFER MODE
Continued
• "SW PLUS " mode is valid only when "FRONT" and "CENTER" are set to "LARGE" and "SUBWOOFER"
is set to "YES" on the SPEAKER / ROOM EQ SETUP menu. (For details, refer to "SETTING THE
SPEAKER / ROOM EQ SETUP" on page 43.)
Note : When the digital signals from DTS, Dolby Digital program sources are input or the EXTERNAL IN is
selected as an input source, you cannot adjust the tone and can listen to a program
source without the tone effect.
OFF : To listen to a program source without the tone effect. ("DIRECT" indicator lights up.)
ON : To adjust the tone for your taste. ("DIRECT" indicator goes off.)
When selecting the TONE CONTROL
When the TONE CONTROL is set to ON to adjust the tone (bass and treble)
1. Press the ENTER button to enter the tone adjustment mode.
2. Press the CURSOR UP(
)/DOWN( ) buttons to select the desired tone mode.
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
3. Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the selected tone as desired.
ENTERENTER
CH.LEVELCH.LEVEL
CHANNELCHANNEL
• The tone level can be adjusted within the range of
-10 ~ +10 dB.
• In general, we recommend the bass and treble to
be adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage
your speakers.
• To complete tone adjustment, repeat the above
steps 2 and 3.