-E25-
VCR Tuner Setting
The built-in VCR is equipped with a channel memory feature
which allows channels to skip up or down to the next channel set
into memory, skipping over unwanted channels. Before selecting
channels, they must be programmed into the VCR’s memory. In
addition to normal VHF and UHF channels, this VCR can receive
up to 125 Cable TV channels. To use this VCR with an antenna,
set the TV/CATV menu option to the TV mode. When shipped
from the factory, this menu option is in the CATV mode.
Preparation:
• Turn ON the TV and set to the video input mode.
• Press [VCR] to select the VCR mode. (The VCR indicator on
the front panel will light.)
Note:
You can’t select “CH SETUP” if you set the channel to “L”.
TV/CATV selection
1. Press [SETUP/MENU].
The “MENU” screen appears on the TV screen.
〈4/5/ENTER/MENU〉
MENU
TIMER REC SET
AUTO REPEAT
ON OFF
ON OFF
SAP
CH SETUP
SYSTEM SETUP
SPEAKER SETUP
TVGuardian SETUP
2. Press [4] or [5] to select “CH SETUP”, then press [ENTER].
〈4/5/ENTER/MENU〉
MENU
TIMER REC SET
AUTO REPEAT
ON OFF
ON OFF
SAP
CH SETUP
SYSTEM SETUP
SPEAKER SETUP
TVGuardian SETUP
3. Press [4] or [5] to select “TV/CATV”.
〈4/5/ENTER/MENU〉
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
4. Press [ENTER] to select the “TV” or “CATV”.
〈4/5/ENTER/MENU〉
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
• The arrow indicates the selected mode.
TV: VHF/UHF channels
CATV: CABLE TV channels
5. Press [SETUP/MENU] until the menu screen is cleared.
Setting channels automatically
The VCR can receive a maximum of 125 channels in CATV
mode, 69 channels in TV mode by presetting the channels into
memory.
1. Repeat left steps 1 ~ 2 and press [4] or [5] to select “AUTO
CH MEMORY”.
〈4/5/ENTER/MENU〉
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
2. Press [ENTER].
The auto tuning will start. The channel display will count up
and when finished, the “CH SETUP” menu will reappear.
3. Press [SETUP/MENU] until the menu screen is cleared.
ENTER
VCR
4,5
SETUP/
MENU
Need help? Call
1-800-813-3435
2B80201A [E] P17-26 24/2/03, 7:14 PM25