Filter
Top Products
The system and the other setup11
94
En
2 Select the surround back speaker setting.
• Normal – Select for normal home theater
use with surround back speakers in your
main (speaker system A) setup.
• Speaker B – Select to use the (surround
back) B speaker terminals to listen to
stereo playback in another room (see
Switching the speaker system on page 68).
• Front Bi-Amp – Select this setting if you’re
bi-amping your front speakers (see Bi-
amping your speakers on page 20).
• ZONE 2 – Select to use the (surround back)
B speaker terminals for an independent
system in another zone (see Using the
MULTI-ZONE controls on page 68).
3 When ‘
Setting Change?
’ is displayed,
select
Yes
.
If No is selected, the setting is not changed.
You will return to the Manual SP Setup menu.
Speaker Setting
Use this setting to specify your speaker
configuration (size, number of speakers and
crossover frequency)
1
. It is a good idea to make
sure that the settings made in Automatically
setting up for surround sound (Auto MCACC) on
page 37 are correct. Note that this setting
applies to all MCACC presets, and cannot be
set independently.
1Select ‘
Speaker Setting
’ from the
Manual SP Setup
menu.
2 Choose the set of speakers that you want
to set, then select a speaker size.
Use / to select the size (and number) of
each of the following speakers:
2
• Front – Select LARGE if your front
speakers reproduce bass frequencies
effectively, or if you didn’t connect a
subwoofer. Select SMALL to send the bass
frequencies to the subwoofer.
• Center – Select LARGE if your center
speaker reproduces bass frequencies
effectively, or select SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect a center
speaker, choose NO (the center channel is
sent to the front speakers).
• Surr – Select LARGE if your surround
speakers reproduce bass freque
ncies
effectively. Se
lect SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect surround
speakers choose NO (the sound of the
surround channels is sent to the front
speakers or a subwoofer).
Note
1If you’re using a THX speaker setup, set all speakers to SMALL.
2 If you select SMALL for the front speakers the subwoofer will automatically be fixed to YES. Also, the center, surround
and surround back speakers can’t be set to LARGE if the front speakers are set to SMALL. In this case, all bass
frequencies are sent to the subwoofer.
1. Surr Back System
2. Speaker Setting
3. Channel Level
4. Speaker Distance
5. X-Curve
4a.Manual SP Setup
A/V RECEIVER
Exit Return
Front : LARGE
Surr : SMALL
Center : SMALL
4a2.Speaker Setting
SB : SMALL x 2
SW : YES
X.OVER : 80Hz
A/V RECEIVER
Exit Return
VSX-1019_DF.book 94 ページ ２００９年３月１３日 金曜日 午前９時５８分