Filter
Top Products
The Advanced MCACC menu10
82
En
Fine Channel Level
• Default setting: 0.0dB (all channels)
You can achieve better surround sound by
properly adjusting the overall balance of your
speaker system. You can adjust the Channel
Level of each speaker in 0.5 dB increments. The
following setting can help you make detailed
adjustments that you may not achieve using
the Manual speaker setup on page 93.
1 Select ‘
Fine Channel Level
’ from the
Manual MCACC
setup menu.
The volume increases to the 0.0 dB reference
level.
2 Adjust the level of the left channel.
This will be the reference speaker level, so you
may want to keep the level around 0.0dB so
that you’ll have plenty of r oom to adjust the
other speaker levels.
•After pressing ENTER, test tones will be
output.
3 Select each channel in turn and adjust the
levels (
+/–10.0 dB
) as necessary.
Use / to adjust the volume of the speaker
you selected to match the reference speaker.
When it sounds like both tones are the same
volume, press to confirm and continue to
the next channel.
•For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use / to select it.
4 When you’re finished, press
RETURN
.
You will return to the Manual MCACC setup
menu.
Fine Speaker Distance
•Default setting: 3.00m (all speakers)
For proper sound depth and separation with
your system, it is necessary to add a slight bit
of delay to some speakers so that all sounds
will arrive at the listening position at the same
time. You can adjust the distance of each
speaker in 1 cm increments. The following
setting can help you make detailed
adjustments that you may not achieve using
the Manual speaker setup on page 93.
1. Fine Channel Level
2. Fine SP Distance
3. Standing Wave
1c.Manual MCACC
4. EQ Adjust
5. EQ Professional
A/V RECEIVER
Exit Return
CAUTION
Loud test tones will be output.
Please wait...**
1c1.Fine Channel Level
A/V RECEIVER
Exit Cancel
A/V RECEIVER
Exit Cancel
MCACC : M1.MEMORY 1
Reference Ch : L
1c1.Fine Channel Level
Ref.Ch Level : 0.0 dB
A/V RECEIVER
Exit Finish
R <=> L
L : 0.0 dB
1c1.Fine Channel Level
R : 0.0 dB
C : 0.0 dB
SR : 0.0 dB
SL : 0.0 dB
SBL : 0.0 dB
SBR : 0.0 dB
SW : 0.0 dB
VSX-1019_DF.book 82 ページ ２００９年３月１３日 金曜日 午前９時５８分