Filter
Top Products
Basic Setup04
38
En
1 Switch on the receiver and your TV.
2 Connect the microphone to the
MCACC
SETUP MIC
jack on the front panel.
•Push down on the PUSH OPEN tab to
access the MCACC SETUP MIC jack.
Place the microphone so that it’s about ear level
at your normal listening position (use a tripod if
possible). Make sure there are no obstacles
between the speakers and the microphone.
The Full Auto MCACC display appears once the
microphone is connected.
1
3Select
Surr Back System
setting,
2
select
an MCACC preset
3
, press and then
select START.
4
Select Normal (Surround back), Speaker B,
Front Bi-Amp or ZONE 2 for the Surr Back
System setting according to connections to
the surround back speaker terminals.
4 Follow the instructions on-screen.
Make sure the microphone is connected, and if
you’re using a subwoofer, make sure it is switched
on and set to a comfortable volume level.
5 Wait for the test tones to finish, then
confirm the speaker configuration in the GUI
screen.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it’s doing this.
5
If no operations are performed for 10 seconds
while the speaker configuration check screen
is being displayed, the Auto MCACC Setup will
resume automatically. In this case, you don’t
need to select ‘OK’ and press ENTER in step 6.
•With error messages (such as Too much
ambient noise! or Check microphone.)
select RETRY after checking for ambient
noise (see Problems when using the Auto
MCACC Setup below) and verifying the mic
connection. If there doesn’t seem to be a
problem, you can simply select GO NEXT
and continue.
Note
1 • You can’t use the HOME MENU when the iPod/USB input function is selected (in either the main or sub zone).
When you set ZONE 2 to ON (page 68), you can’t use the HOME MENU.
• If you leave the GUI screen for over five minutes, the screen saver will appear.
MASTER
VOLUME
MCACC
SETUP
MIC
SPEAKERS
VIDEO L RAUDIO
CONTROL
MULTI-ZONE
ON
/
OFF
VIDEO
INPUT
VIDEO INPUT
RL AUDIOVIDEO
USB
MCACC
SETUP MIC
USB
iPod
iPhone
iPod
iPhone
Surr Back System : Normal
1a.Full Auto MCACC
A/V RECEIVER
Exit Return
START
Save SYMMETRY to : M1.MEMORY 1
2 • If you are planning on bi-amping your front speakers, or setting up a separate speaker system in another room, read
through Surround back speaker setting on page 93 and make sure to connect your speakers as necessary before
continuing to step 4.
• If you have THX-certified speakers, select Return, then select Auto MCACC for the THX Speaker setting. See
Automatic MCACC (Expert) on page 77 for more on this.
3The six MCACC presets are used for storing surround sound settings for different listening positions. Simply choose
an unused preset for no
w (you can re
name it later in Data Management on page 90).
4Note that correction curves are saved only when set to SYMMETRY. Select Return, then select Auto MCACC to save
other correction curves (such as ALL CH ADJ and FRONT ALIGN). See Automatic MCACC (Expert) on page 77 for
more on this.
5 Do not adjust the volume during the test tones. This may result in incorrect speaker settings.
RECEIVER
VSX-1019_DF.book 38 ページ ２００９年３月１３日 金曜日 午前９時５８分