Filter
Top Products
Connecting your equipment 03
35
En
Plugging in the receiver
After you’ve finished making all connections,
plug the receiver into an AC outlet. The type of
cord and the plug converter which can be used
depends on the power voltage in each region or
country. Please make sure you use the correct
cord and plug converter due to the possibility
of fire or other hazard if used incorrectly (see
below).
1 Plug the supplied power cord into the
AC
IN
socket on the back of the receiver.
2 Plug the other end into a power outlet.
1
CAUTION
• Handle the power cord by the plug part. Do
not pull out the plug by tugging the cord,
and never touch the power cord when your
hands are wet, as this could cause a short
circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on
the power cord or pinch the cord in any
other way. Never make a knot in the cord or
tie it with other cables. The power cords
should be routed so that they are not likely
to be stepped on. A damaged power cord
ca
n
cause a fire or give you an electric
shock. Check the power cord once in a
while. If you find it damaged, ask your
nearest Pioneer authorized independent
service company for a replacement.
•Do not use any power cord other than the
one supplied with this unit.
• Do not use the supplied power cord for any
purpose other than that described below.
•The receiver should be disconnected by
removing the mains plug from the wall
socket when not in regular use, e.g., when
on vacation.
•Make sure the blue STANDBY/ON light
has gone out before unplugging.
• If you have connected speakers with a 6
Ω
impedance, change the impedance setting
before turning on the power.
AC power cord and converter plug use
Region Plug type
For European type region
Caution
Do not use this power
cord set in Singapore and
Malaysia.
European two-pin plug
For regions with two pin
flat-bladed plug
Caution
Do not use this power
cord set in Taiwan.
European two-pin plug with
two-pin flat-bladed converter
plug
For Taiwan exclusively
Caution
For use in Taiwan only. In
other areas, please do
not use.
Taiwanese two-pin flat-
bladed plug
For Australian and New
Zealand exclusively
AS 3112 flat two-pin plug
Note
1After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You
cannot carry out any operations during this process. The HDMI indicator in the front panel display blinks during this
process, and you can turn on this receiver once it has stopped blinking. When you set the KURO LINK mode to OFF,
you can skip this process. For details about the KURO LINK feature, see KURO LINK on page 59.
VSX-1019_DF.book 35 ページ ２００９年３月１３日 金曜日 午前９時５８分