Filter
Top Products
Using other functions 08
71
En
Resetting the system
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front panel
controls to do this. Set
MULTI-ZONE
to
OFF
.
• Disconnect the iPod and USB memory
device from the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front
panel, press
STANDBY/ON
.
The display shows RESET NO .
3 Select ‘
RESET
’ using
PRESET +/–
, then
press
ENTER
on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
• Note that all settings will be saved, even if
the receiver is unplugged.
Default system settings
Setting Default
Digital Video Conversion ON
SPEAKERS A
Surround Back System Normal
Speaker System Front SMALL
Center SMALL
Surr SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
DIMMER brightest
Inputs
See Input function default and possible settings on
page 41.
MULTI-ZONE
ZONE 2 Volume Level Variable
ZONE 2 Volume –60 dB
HDMI
HDMI Audio Amp
KURO LINK ON
DSP
Surround back channel
Processing
ON
Phase Control ON
Sound Retriever
iPod/USB
function
ON
Other functions
OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Up Mix ON
Digital Safety OFF
Effect Level ExtendedStereo 90
Other modes 50
2 PL II Music
Options
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode
(HP)
STEREO
See also Setting the Audio options on page 63 for
other default DSP settings.
MCACC
MCACC Position Memory M1: MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 3.00 m
Standing Wave
(M1 to M6)
ATT of all
channels/filters
0.0 dB
SWch Wide
Trim
0.0 dB
EQ Data (M1 to
M6)
All channels/
bands
0.0 dB
EQ Wide Trim 0.0 dB
Setting Default
VSX-1019_DF.book 71 ページ ２００９年３月１３日 金曜日 午前９時５８分