Filter
Top Products
Additional information12
110
En
Important information regarding the HDMI connection
There are cases where you may not be able to route HDMI signals through this receiver (this
depends on the HDMI-equipped component you are connecting–check with the manufacturer for
HDMI compatibility information).
If you aren’t receiving HDMI signals properly through this receiver (from your component), please
try one of the following configurations when connecting up.
Configuration A
Use component video cables to connect the
video output of your HDMI-equipped
component to the receiver’s component video
input. The receiver can then convert the analog
component video signal to a digital HDMI
signal for transmission to the display. For this
configuration, use the most convenient
connection (digital is recommended) for
sending audio to the receiver. See the
operating instructions for more on audio
connections.
Note
•The picture quality will change slightly
during conversion.
Configuration B
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is r ecommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
Note
•If your display only has one HDMI terminal,
you can only receive HDMI video from the
connected comp onent.
•Depending on the component, audio
output may be limited to the number of
channels available from the connected
display unit (for example audio outp ut is
reduced to 2 channels for a monitor with
stereo audio limitations).
• If you want to switch the input function,
you’ll have to switch functions on both the
receiver and your display unit.
• Since the sound is muted on the display
when using the HDMI connection, you
must adjust the volume on the displa
y
eve
ry time you switch input functions.
Amp-linked operation not
possible using KURO LINK
function.
• Check the HDMI connections.
• The cable may be damaged.
• Select ON for the KURO LINK setting (see KURO LINK Setup on page 61).
• Turn the TV’s power on before turning on this receiver’s power.
• Set the TV side KURO LINK setting to ON.
Symptom Remedy
VSX-1019_DF.book 110 ページ ２００９年３月１３日 金曜日 午前９時５８分