Filter
Top Products
Using other functions 08
67
En
Setting the Video options
There are a number of additional picture
settings you can make using the VIDEO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• Note that if an option cannot be selected
on the VIDEO PARAMETER menu, it is
unavailable due to the current source,
setting and status of the receiver.
• These functions do not affect HDMI inputs.
1 Press , then press
VIDEO
PARAMETER
.
2Use
/
to select the setting you want to
adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on
this.
3Use
/
to set it as necessary.
See the table below for the options available for
each setting.
1
4Press
RETURN
to confirm and exit the
menu.
Note
1 • All of the setting items can be set for each input function.
• Setting items other than V. CONV can only be selected when V. CONV is set to ON.
RECEIVER
Setting What it does Option(s)
V. CONV
(Digital Video Conversion)
Converts video signals for output from the MONITOR OUT jacks
(including HDMI OUT connector) for all video types (see page 22).
ON
OFF
RES
a
(Resolution)
*VSX-1019AH model only
Specifies the output resolution of the video signal (when analog
video input signals are output at the HDMI OUT connector, select
this according to the resolution of your monitor and the images
you wish to watch).
AUTO
PURE
480p/576p
720p
1080i
1080p
ASP
b
(Aspect)
*VSX-1019AH model only
Specifies the aspect ratio when analog video input signals are
output at the HDMI output. Make your desired settings while
checking each setting on your display (if the image doesn’t match
your monitor type, cropping or black bands appear).
THROUGH
NORMAL
IP CONV
c,d
(I/P Converter)
*VSX-919AH model only
480i/576i analog video signals are converted to progressive
signals for output.
When set to AUTO, the signals are output with the optimum
setting for the connected display by HDMI.
When set to ON, the signals are up-converted to 480p/576p for
output.
When set to OFF, the signals are not converted for output.
AUTO
ON
OFF
VSX-1019_KU.book Page 67 Thursday, January 8, 2009 12:01 PM