Filter
Top Products
Additional information 12
109
En
Remote control
HDMI
Symptom Remedy
Cannot be remote controlled. • Set a 5-digit preset code corresponding to the receiver to be operated in the
remote control (see Operating multiple receivers on page 73).
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup on page 101).
• Try replacing the batteries in the remote control (see Loading the batteries on
page 7).
• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor
on the front panel (see Operating range of remote control unit on page 13).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the CONTROL IN jack (see Operating other Pioneer
components with this unit’s sensor on page 32).
Other components can’t be
operated with the system
remote.
• If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
Symptom Remedy
The HDMI indicator blinks
continuously.
• Check all the points below.
No picture or sound. • This receiver is HDCP-compatible. Check that the components you are
connecting are also HDCP-compatible. If they are not, please connect them
using the component or composite video jacks.
• Depending on the connected source component, it’s possible that it will not
work with this receiver (even if it is HDCP-compatible). In this case, connect
using the component or composite video jacks between source and receiver.
• If the problem still persists when connecting your HDMI component directly
to your monitor, please consult the component or monitor manual or contact
the manufacturer for support.
• If video images do not appear on your TV or flat panel TV, try adjusting the
resolution, DeepColor or other setting for your component.
• If ‘NOT SUPPORT’ appears in the receiver’s display, try adjusting the
resolution, DeepColor or other setting for your component.
• While analog video signals are being output over HDMI, use a separate
connection for audio output.
• When this receiver reproduces MULTI CH IN audio sources with the HDMI
setting set to THROUGH, you cannot hear audio output from all channels. In
this case, make a digital or analog audio connection.
• To output signals in DeepColor, use an HDMI cable (High Speed HDMI™
Cable) to connect this receiver to a component or TV with the DeepColor
feature.
No picture. • Try changing the Resolution setting (in Setting the Video options on page 67).
VSX-1019_KU.book Page 109 Thursday, January 8, 2009 12:01 PM