Filter
Top Products
Basic playback05
42
En
Playing a source with HDMI
connection
•Use
INPUT SELECT
to select the HDMI
input you’ve connected to (for example,
HDMI 1
).
You can also perform the same operation by
using the INPUT SELECTOR dial on the front
panel or by pressing HDMI on the remote
control repeatedly.
• Set the HDMI parameter in Setting the
Audio options on page 64 to THROUGH if
you want to hear HDMI audio output from
your TV or flat panel TV (no sound will be
heard from this receiver).
• If the video signal does not appear on your
TV or flat panel TV, try adjusting the
resolution settings on your component or
display. Note that some components (such
as video game units) have resolutions that
may not be converted. In this case, use an
analog video connection.
Selecting the multichannel analog
inputs
If you have connected a decoder or a DVD
player as above, you must select the analog
multichannel inputs for surround sound
playback.
1
1 Make sure you have set the playback
source to the proper output setting.
For example, you might need to set your DVD
player to output multichannel analog audio.
2Use
INPUT SELECT
to select
MULTI CH IN
.
You can also use the INPUT SELECTOR dial on
the front panel.
• Depending on the DVD player you’re using,
the analog output level of the subwoofer
channel may be too low. In this case, the
output level of the subwoofer can be
increased by 10 dB in the Multi Ch In
Setup in Other Setup. For details, see
Multi Channel Input Setup on page 99.
Note
1 • When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
• You can’t listen to your speaker B system during playback from the multichannel inputs.
• With MULTI CH IN inputs, it is possible to play pictures simultaneously. For details, see Multi Channel Input Setup
on page 99.
VSX-1019_KU.book Page 42 Thursday, January 8, 2009 12:01 PM