Filter
Top Products
Basic playback05
52
En
3Press
D.ACCESS
(Direct Access).
4 Use the number buttons to enter the
frequency of the radio station.
For example, to tune to 106.00 (FM), press 1, 0,
6, 0, 0.
If you make a mistake halfway through, press
D.ACCESS twice to cancel the frequency and
start over.
Saving station presets
If you often listen to a particular radio station,
it’s convenient to have the receiver store the
frequency for easy recall whenever you want to
listen to that station. This saves the effort of
manually tuning in each time. This receiver can
memorize up to 63 stations, stored in seven
banks, or classes (A to G) of 9 stations each.
When saving an FM frequency, the MPX
setting (see page 51) is also stored.
1 Tune to a station you want to memorize.
See Listening to the radio on page 51 for more
on this.
2Press
T.EDIT
(
TUNER EDIT
).
The display shows PRESET MEMORY, then a
blinking memory class.
3Press
CLASS
to select one of the seven
classes, then press
PRESET
/
to select the
station preset you want.
You can also use the number buttons to select
a station preset.
4Press
ENTER
.
After pressing ENTER, the preset class and
number stop blinking and the receiver stores
the station.
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets below for how
to do this.
2 Press
T.EDIT
(
TUNER EDIT
).
The display shows PRESET NAME, then a
blinking cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a
name up to eight characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()
∗+,–./:;<=>?@[ \ ]^_{|} ˜ [space]
Use / to select a character, / to set the
position, and ENTER to confirm your selection.
Tip
• To erase a station name, simply repeat
steps 1 to 3 and input eight spaces instead
of a name.
• Once you have named a station preset, you
can press DISP when listening to a station
to switch the display between name and
frequency.
Listening to station presets
You will need to have some presets stored to do
this. See Saving station presets above if you
haven’t done this already.
1 Press
TUNER
to select the tuner.
2 Press
CLASS
to select the class in which
the station is stored.
Press repeatedly to cycle through classes A to G.
3 Press
PRESET
/
to select the station
preset you want.
• You can also use the number buttons on the
remote control to recall the station preset.
VSX-1019_KU.book Page 52 Thursday, January 8, 2009 12:01 PM