Filter
Top Products
Additional information12
112
En
SIRIUS radio messages
If the problem is not solved after the troubleshooting above, if the screen freezes unexpectedly or
if the buttons on the remote control or front panel stop working completely, do the following:
• Press STANDBY/ON on the front panel to turn off the power, then turn the power back on.
• If the power cannot be turned off, press and hold STANDBY/ON on the front panel for over
10 seconds. The power will turn off. (In this case, the various settings made on the receiver may
be cleared.)
A USB memory device is
connected and displayed,
but the audio files stored
on the USB memory
device cannot be played
back.
Some formats of a USB memory
device, including FAT 12, NTFS, and
HFS, cannot be played back on this
receiver.
Check whether the format of your USB
memory device is either FAT 16 or FAT 32.
Note that the FAT 12, NTFS, and HFS
formats cannot be played back on this
receiver (page 45).
The file format cannot be properly
played back on this receiver.
See the list of file formats that can be played
back on this receiver (page 48).
Message Cause Action
Antenna ERROR Antenna is not properly connected. Check that the antenna cable is attached
securely.
Check Sirius Tuner SIRIUS Connect tuner is not
properly connected.
Check that the 8 pin mini DIN cable and AC
Adapter are attached securely.
Acquiring Signal The SIRIUS signal is too weak at the
current location.
n/a
Subscription Updating Unit is updating subscription. Wait until the encryption code has been
updated.
Updating Channels Unit is updating channels. Wait until the encryption code has been
updated.
Invalid Channel Selected channel is not available/
does not exist.
Select another channel.
Firmware Updating The SIRIUS Connect tuner’s
firmware is being updated.
Wait for updating to finish.
Symptoms Causes Remedies
VSX-1019_KU.book Page 112 Thursday, January 8, 2009 12:01 PM