Filter
Top Products
The system and the other setup 11
101
En
Remote Control Mode Setup
•Default setting: 1
This sets this receiver’s remote control mode to
prevent erroneous operation when multiple
units of the receiver are being used.
1
1 Select ‘
Remote Control Mode Setup
’
from the
Other Setup
menu.
2 Select the
Remote Control Mode
setting
you want.
3 Select “
OK
” to change the remote control
mode.
4 Follow the instructions on the screen to
change the remote control’s setting.
See Operating multiple receivers on page 73.
5 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
Flicker Reduction Setup
•Default setting: 4
The GUI screen’s resolution can be increased.
If you feel the GUI screen is hard to see, try
changing this setting. Note that the resolution
in this setting only affects the GUI screen; it
has no influence on the video output.
1 Select ‘
Flicker Reduction Setup
’ from the
Other Setup
menu.
2 Select the Flicker Reduction setting you
want.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
Note
1 If you change this receiver’s setting, also change the setting on the remote control.
4d.Other Setup
A/V RECEIVER
Exit Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6.
Remote Control Mode Setup
7.
Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d6.Remote Control Mode Setup
A/V RECEIVER
Exit Cancel
Remote Control Mode : 1
OK
4d.Other Setup
A/V RECEIVER
Exit Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6.
Remote Control Mode Setup
7.
Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d7.Flicker Reduction Setup
A/V RECEIVER
Exit Finish
Flicker Reduction : 4
VSX-1019_KU.book Page 101 Thursday, January 8, 2009 12:01 PM