Filter
Top Products
Connecting your equipment 03
35
En
Connecting a USB device
It is possible to playback files using the USB
interface on the front of this receiver.
• Switch the receiver into standby then
connect your USB device to the iPod/iPhone/
USB terminal on the front panel of this
receiver.
• Push down on the PUSH OPEN tab to
access the
iPod/iPhone/USB
terminal.
Plugging in the receiver
Only plug in after you have connected all your
components to this receiver, including the
speakers.
• Plug the AC power cord into a convenient
AC power outlet.
1
CAUTION
• Handle the power cord by the plug part. Do
not pull out the plug by tugging the cord,
and never touch the power cord when your
hands are wet, as this could cause a short
circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on
the power cord or pinch the cord in any
other way. Never make a knot in the cord or
tie it with other cables. The power cords
should be routed so that they are not likely
to be stepped on. A damaged power cord
can cause a fire or give you an electric
shock. Check the power cord once in a
while. If you find it damaged, ask your
nearest Pioneer authorized independent
service company for a replacement.
• The receiver should be disconnected by
removing the mains plug from the wall
socket when not in regular use, e.g., when
on vacation.
•Make sure the blue STANDBY/ON light
has gone out before unplugging.
• If you have connected speakers with a 6
Ω
impedance, change the impedance setting
before turning on the power.
MASTER
VOLUME
MCACC
SETUP
MIC
SPEAKERS
VIDEO L RAUDIO
CONTROL
MULTI-ZONE
ON
/
OFF
VIDEO
INPUT
VIDEO INPUT
RL AUDIOVIDEO
iPo
iPhone
d
USB
MCACC
SETUP MIC
USB
i
iPhone
Pod
USB mass
storage device
This receiver
Note
1 After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You
cannot carry out any operations during this process. The HDMI indicator in the front panel display blinks during this
process, and you can turn on this receiver once it has stopped blinking. When you set the KURO LINK mode to OFF,
you can skip this process. For details about the KURO LINK feature, see KURO LINK on page 60.
VSX-1019_KU.book Page 35 Thursday, January 8, 2009 12:01 PM