Filter
Top Products
HDMI Control
11
90
En
Setting the HDMI options
You must adjust the settings of this receiver as well as
HDMI Control-compatible connected components in
order to make use of the HDMI Control function. For
more information see the operating instructions for each
component.
Setting the HDMI Control mode
Choose whether to set this unit’s HDMI Control function
ON or OFF. You will need to set it to ON to use the HDMI
Control function.
• When using a TV not manufactured by Pioneer, put
this setting to OFF.
1 Set the operation selector switch to
RCV
, then press
SETUP
.
2 Select ‘
System Setup
’, then press
ENTER
.
3 Select ‘
Other Setup
’, then press
ENTER
.
4 Select ‘
HDMI Control Setup
’ from the
Other Setup
menu.
5 Select the ‘
HDMI Control
’ setting you want.
• ON – Enables the HDMI Control function. When this
unit’s power is turned off and you have a supported
source begin playback while using the HDMI Control
function, the audio and video output from the HDMI
connection are output from the flat panel TV.
1
• OFF – The HDMI Control is disabled. Synchronized
operations cannot be used. When this unit’s power is
turned off, audio and video of sources connected via
HDMI are not output.
6 Only when
ON
was selected at step 5: Select
AUTO
or
OFF
for the PQLS setting.
• AUTO – PQLS is enabled. A precision quartz
controller in this receiver eliminates distortion
caused by timing errors (jitter), giving you the best
possible digital-to-analog conversion from audio CD
sources when you use the HDMI interface. This is
valid as an HDMI function for PQLS-compatible
players.
2
• OFF – PQLS is disabled.
7 When you’re finished, press
HOME MENU
.
You will finish to HOME MENU.
Before using synchronization
Once you have finished all connections and settings, you
must:
1 Put all components into standby mode.
2 Turn the power on for all components, with the
power for the flat panel TV being turned on last.
3 Choose the HDMI input to which the TV is
connected to this receiver, and see if video output from
connected components displays properly on the screen
or not.
4 Check whether the components connected to all
HDMI inputs are properly displayed.
Note
1• When HDMI Control is set to ON, the audio/video signals input at the HDMI IN terminals are output at the HDMI OUT terminal even when
this receiver is switched off.
• With HDMI Control set to ON, Input Setup and HDMI Input are automatically set to off.
1. Multi Ch In Setup
2. ZONE Audio Setup
3. SR+ Setup
5. Flicker Reduction Setup
4. HDMI Control Setup
4d.Other Setup
A/V RECEIVER
Exit Return
4d4.HDMI Control Setup
A/V RECEIVER
Exit Finish
HDMI Control : ON
PQLS : AUTO
2 • When this set is connected by HDMI cable to a Pioneer player that is compatible with the PQLS function via HDMI connection and a CD is
played or HDMI re-authentication is performed (the HDMI indicator blinks), the PQLS effect is enabled and the listening mode is set to stereo.
• If a listening mode other than stereo is selected while the PQLS effect is enabled, the PQLS effect is disabled.
4d4.HDMI Control Setup
A/V RECEIVER
Exit Finish
HDMI Control : ON
PQLS : AUTO
SC07-05.book Page 90 Friday, April 25, 2008 11:59 AM