Filter
Top Products
Additional information
15
121
En
About status messages
Refer to the following information when you come up with a status message while operating the Home Media Gallery.
XM radio messages
The Home Media Gallery
cannot be operated with
the buttons on the remote
control.
The remote control is not currently set to the
Home Media Gallery mode.
Press HOME MEDIA GALLERY to set the
remote control to the Home Media Gallery
mode.
76
Status messages Descriptions
Please Wait A component on the network, including a PC, is currently being connected. Wait for a while.
Connection Down The selected category or Internet radio station cannot be accessed.
File Format Error Cannot be played back for some reasons.
Track Not Found The selected song has not been found anywhere on the network.
Server Error The selected server cannot be accessed.
Server Disconnected The server has been disconnected.
USB Error 1 The amount of electricity consumption for a USB memory device is too large.
empty There are no files stored in the selected folder.
Preset Not Stored The selected Internet radio station is not currently registered and saved.
Network Problem There is a problem with the network settings. Check the network settings. The message also
appears then the network settings of this receiver have been changed. In this case, please
wait.
Out of Range The value entered is beyond the permitted range of the network settings.
License Error The license for the contents to be played back is invalid.
Item Already Exists This is displayed when the file you have attempted to register in the Favorites folder has
already been registered.
Favorite List Full This is displayed when you have attempted to register a file in the Favorites folder but the
Favorites folder is already full.
Symptoms Causes Remedies Refer to
Symptom Cause Action
Check XM Tuner The XM Mini-Tuner is not installed or not fully seated
in the XM Mini-Tuner Dock or the XM Mini-Tuner
dock is not connected to this receiver.
Confirm the XM Mini-Tuner is fully seated in the dock
and check the XM Mini-Tuner dock cable is
connected to this receiver.
Check Antenna The XM antenna is not connected to the XM Mini-
Tuner Dock or the XM antenna cable is damaged.
Check that the XM antenna is securely connected to
the XM Mini-Tuner Dock and check the antenna
cable for damage. Replace the XM antenna if the
cable is damaged.
Loading The XM Mini-Tuner is acquiring audio or program
information from the XM satellite signal. This
message can also occur in weak XM signal
conditions.
Note that this receiver may not respond to some
buttons while this message is displayed.
This message should disappear in a few seconds in
good signal conditions.
If you see this message often, reposition the XM
antenna for better signal reception.
Use the Antenna Aiming option to optimize the
antenna position.
No Signal The XM Mini-Tuner is not receiving the XM satellite
signal. Something may be blocking the XM
antenna’s view of the satellites or the antenna is not
properly aimed.
Check for antenna obstructions and reposition the
XM antenna to get better signal reception. Use the
Antenna Aiming option to optimize the antenna
position.
See instructions supplied with the XM Mini-Tuner
and Dock for antenna installation information.
Off Air The XM channel you selected is not currently
broadcasting.
Check back later; in the mean time, select another
channel.
SC07-05.book Page 121 Friday, April 25, 2008 11:59 AM