Filter
Top Products
Using other functions
13
100
En
Switching the HDMI output
SC-07 only
Set which terminal to use when outputting video and
audio signals from the HDMI output terminals (HDMI
OUT1, HDMI OUT2 or HDMI OUT ALL).
The HDMI OUT1 terminal is compatible with the HDMI
control function.
• Set the operation selector switch to
RCV
, then press
HDMI OUT
.
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT1, HDMI OUT2
and HDMI OUT ALL each time the button is pressed.
1
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Set the operation selector switch to
RCV
, then press
STATUS
to check the system settings.
These appear on the front panel display.
2
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press
STATUS
again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
1 Switch the receiver into standby.
2 While holding down
HOME MENU
on the front
panel, press
STANDBY/ON
.
The display shows RESET NO .
3 Press
ENTER
on the front panel.
4 Select ‘
RESET
’ using
/
, then press
ENTER
on
the front panel.
The display shows RESET? OK.
5 Press
ENTER
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Note
1• Synchronized amp mode on page 91 is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch
to HDMI OUT1, then select the synchronized amp mode on the flat panel TV using the flat panel TV’s remote control.
• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI3, or BD.
2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
Input source
↓
Surround Back Processing
↓
MCACC preset
↓
ZONE 2 input
↓
ZONE 3 input
↓
HDMI Control
↓
HDMI OUT
SOURCE
TV RCV
VOL
VOLCH
SOURCE
TV RCV
SIGNAL SEL SLEEP AUDIODIMMER
SR+
CLR
SBch MCACC
A.ATT GENRE
HDMI OUT
D.ACCESS
ENTER
CLASS
DISP
CH
A.ATT
SOURCE
TV RCV
VOL
VOL
TV CONTROL
CH
SOURCE
TV RCV
iPod CTRL
CATEGORY
HOME
MENU
STATUS
THX MPX MEMORY
PHASE CTRL CH LEVEL
TUNE
PGM
STEREO/
A.L.C.
BD MENU
AUTO/
DIRECT
STANDARD ADV SURR
RETURN
STATUS
SC07-05.book Page 100 Friday, April 25, 2008 11:59 AM