Filter
Top Products
56
UP-A1 series Dock for iPod—Continued
Operating Notes:
• Before selecting a different input source, stop iPod
playback to prevent the AV receiver from selecting the
iPod input source by mistake.
• If any accessories are connected to your iPod, the AV
receiver may not be able to select the input source
properly.
• While your iPod is in the UP-A1 series Dock, its vol-
ume control has no effect. If you adjust your iPod
models volume control while it’s in the UP-A1 series
Dock, make sure it’s not set too high before you recon-
nect your headphones.
■ Using Your iPod models Alarm Clock
You can use your iPod models Alarm Clock function to
automatically turn on your iPod and the AV receiver at a
specified time. The AV receiver’s input source will auto-
matically be set to the [PORT] selector.
Notes:
• To use this function, your iPod must be in the UP-A1
series Dock, and the UP-A1 series Dock must be con-
nected to the AV receiver.
• When you use this function, be sure to set the AV
receiver’s volume control to a suitable level.
• The AV receiver may take several seconds to startup,
so you might not hear the first few seconds of the first
song.
■ Charging Your iPod models Battery
The UP-A1 series Dock charges your iPod models bat-
tery while your iPod is in the UP-A1 series Dock and
connected to the UNIVERSAL PORT jacks on the AV
receiver. While your iPod is seated in the UP-A1 series
Dock, its battery will be charged when the AV receiver is
set to “On” or “Standby”.
Note:
When UP-A1 series Dock that seated iPod is connected,
the power consumption on standby mode slightly
increases.
By pressing the REMOTE MODE button that’s been
programmed with the remote control code for your
Dock, you can control your iPod in the Dock with the
following buttons.
The [PORT] button is preprogrammed with the remote
control code for controlling a Dock with Universal Port
connector.
For details on entering a remote control code, see
page 88.
When Using a Dock with Universal Port connector:
• Connect the Dock to the UNIVERSAL PORT jack.
• See to the Dock’s instruction manual for more infor-
mation.
You can control your iPod when “PORT” is selected as
the input source.
Note:
For detailed operation of the iPod, please refer to the
instruction manual.
Controlling iPod
Press [PORT] button first