Onkyo 29400095 Stereo Receiver User Manual


 
46
First Time Setup—Continued
Using Audyssey 2EQ™
The onscreen setup menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected
to the MONITOR OUT V or the COMPONENT
VIDEO OUT, use the AV receiver’s display when
changing settings.
1
Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
ENTER
ON/STANDBY
Speaker setup
microphone
Notes:
If the AV receiver is muted, it will be unmuted
automatically when the Audyssey 2EQ Room
Correction and Speaker Setup starts.
Room correction and speaker setup cannot be
performed while a pair of headphones is
connected.
It takes about 15 minutes to complete the room
correction and speaker setup for three positions.
Total measurement time varies depending on the
number of speakers.
Do not disconnect the speaker setup microphone
during the room correction and speaker setup,
unless you want to cancel the setup.
Do not connect or disconnect any speakers during
the room correction and speaker setup.
2
Set the speaker setup micro-
phone at the Main Listening Posi-
tion 1 (page 45), and connect it
to the SETUP MIC jack.
The speaker setting menu appears.
If you change these settings, refer to
step 5 on “Speaker Settings” (page 42)
or step 4 on “Setting the Powered Zone
2” (page 83).
3
When you’ve finished, press the
[ENTER] button.
Notes:
Before starting Audyssey 2EQ™
Room Correction and Speaker Setup,
arrange the room and connect the
speakers as you would for enjoying
movies. Changes to the room after
auto setup requires you run the auto
setup again, as room EQ
characteristics may have changed.
When starting the room correction
and speaker setup, do not stand
between the speakers and
microphone, and avoid obstacles
blocking the path between speakers
and microphone. This will produce
inaccurate results.
Position the microphone at ear height
of a seated listener with the
microphone tip pointed directly at
the ceiling using a tripod. Do not
hold the microphone in your hand
during measurements as this will
produce innacurate results.
2EQ: Auto Setup
Enter : Next
Speaker Type
Powered Zone 2
Surr Back/Front High
Normal
Not Act
Surr Back
2EQ: Auto Setup
Please place setup microphone at center
of listening area at ear height.
Next