Filter
Top Products
6.12 Attachment (A95*GOT only)
6.12.1 Attachment type
6 - 29
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
PERFORMANCE
4
NAMES OF
THE PARTS AND
THEIR SETTINGS
5
ROUGH
PRE-OPERATION
PROCEDURE
6
HANDLING
7
MAINTENANCE AND
INSPECTION
8
EMC DIRECTIVE
6.12 Attachment (A95*GOT only)
The attachment is used to replace the A85*GOT with the A95*GOT.
By the use of the attachment, additional machining to the installation hole in the control panel of the
A85*GOT can be eliminated.
6.12.1 Attachment type
The following Attachment type is available.
6.12.2 Mounting procedure
• The attachment can be used when the plate thickness of the installation panel is 1.2 (0.05) to 3
mm (0.12 in).
When the plate thickness exceeds 3 mm (0.12 in), the attachment cannot be used for the
replacement of the GOT.
• Once the GOT has been replaced with a new GOT by the use of the attachment, the new GOT
does not meet the requirements specified in the standards for water and dust resistance IP65/
IP67/NEMA4.
Type Model in use Applicable model
A85GT-95ATT A85*GOT A95*GOT
1) Peel off the pressure sensitive adhesive double coated tape
from the rear surface of the attachment.
2) Install the attachment securely taking care so that it is
positioned correctly in the installation panel mounting hole.
If the installation panel is dirty, the attachment may fall,
causing injury.
Ensure to clean the installation panel by wiping it off before
installation of the attachment.
3) Insert the GOT main unit from the front of the attachment,
and tighten it to the specified torque using the mounting
screws furnished with the GOT main unit.
Installation panel
Attachment
Installation panel
A95 GOT