Filter
Top Products
2.6 Notes on Q4ARCPU Duplex System
2 - 11
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
PERFORMANCE
4
NAMES OF
THE PARTS AND
THEIR SETTINGS
5
ROUGH
PRE-OPERATION
PROCEDURE
6
HANDLING
7
MAINTENANCE AND
INSPECTION
8
EMC DIRECTIVE
2.6 Notes on Q4ARCPU Duplex System
This section describes the notes on the connecting of the Q4ARCPU with the GOT, as follows:
(1) Notes on the additional base for duplex system at the final stage:
To connect the duplex system with the GOT via the bus, connect the GOT with the additional base
for duplex system (A68RB) that is provided at the final stage of the duplex system. To use the
additional base for duplex system, please apply that of the Version B or after.
• In the following configurations the GOT will not operate normally as specified.
(a) The configuration in which the GOT is connected with the fundamental base for the duplex
system (A32RB, A33RB) is connected via the bus.
(b) The configuration in which the GOT is connected with the additional base (A68RB) for duplex
system of Version A is connected via the bus.
• To check and confirm the version of the additional base for duplex system, please refer to the
DATE column on the rating plate that is adhered to the part as shown in the illustration below.
MITSUBISHI
PROGRAMMABLE CONTROLLER
MITSUBISHI ELECTRIC CORP.
JAPAN
DATE
9806 B
Version of additional base
for duplex system
Magnified illustration of rating plate
CAUTION