Filter
Top Products
MAXX-2400HD Owner’s Manual Page 47
Ejecting a Clip
Ejecting a clip effectively removes it from the transport. The channel will output Black. Press
EJECT to eject a clip.
Using Jog
The JOG + command will move to the next frame and go to Still. The JOG– command will
move to the previous frame and go to Still.
Using GO-TO
Click the arrows
|
< or >
|
to go to the next trim point (Mark In or Mark Out) in the selected
direction. When in Edit mode, an additional click in the selected direction will go to the actual
beginning or end of the entire clip.
Using Fast Forward / Rewind
F-F (Fast Forward) and REW (Rewind) buttons transport program material at high speed in the
chosen direction. Four speed choices are available in each direction. Click the button repeatedly for:
4x, 16x, 64x, and 128x. Audio does not play at any speed beyond +/- 2X.
Slow Motion Playback
The MAXX-2400HD will play smooth slow-motion video in forward or reverse, at any speed
from zero to 2X. Direction can be instantly changed, using either the GUI or a desk-top controller.
Audio is also played at these lower speeds. At speeds beyond 2X, video frames will selected as
needed, yielding a chunky result; audio is muted at high speeds. Most slo-mo playback for sports and
other uses lies well within the 2X zone.
To play in slow motion from the GUI, press PLAY and then move the shuttle slider to the desired
speed—within a range of 2X range forward or reverse. See the following section for details on the
Shuttle control. For faster playback from the GUI, use the FAST FORWARD or REWIND buttons as
described in the preceding section.
In sports, slow-motion control is usually accomplished with a desk-top slow-mo controller, such
as those made by DNF Controls and others. These provide a hands-on experience far preferable to
using the GUI.
Using Shuttle to Control Playback Speed
The Shuttle Control is a slider bar that controls playback speed. Playback speed control employs
varispeed algorithms that may skip frames. It is not a perfect fast motion mechanism.
The center position represents zero speed, or Still.
The right and left extents of the slider represent ±2x maximums.
The Shuttle control slider works in three basic ways: Snap-Back to still, Hold Speed, and Mouse
Wheel.
• In Snap-Back operation, click and drag the slide control to change speed. Releasing the slider bar
will let it snap back to zero speed, or still.