Filter
Top Products
MAXX-2400HD Owner’s Manual Page 23
Connecting the Monitor, Mouse and Keyboard
The MAXX-2400HD is not shipped with a video monitor. Select a VESA-compliant CRT or
LCD monitor with a minimum refresh rate of 75 Hz. Note that the MAXX-2400HD may not start
correctly if an unsuitable monitor is connected. Connect the monitor to the VGA port on the rear of
the unit. Refer to Figure 2 on Page 24
Connect the keyboard to the PS-2 keyboard port on the rear of the unit; connect the mouse to
the mouse port. Refer to Figure 2 on page 24. NOTE: If the mouse and keyboard connections are
interchanged, the MAXX-2400HD may not boot up properly. Be especially careful about this
when using extender cables.
If you own more than one MAXX-2400HD, it may be appropriate to use a single keyboard,
monitor, and mouse with a KVM switch to select between servers. Not all KVM switching systems
are compatible. The KVM switch must supply an active signal to the server at all times, even when
switched away from it. When first powering up the MAXX-2400HD, use only the supplied
keyboard and mouse directly connected. Then test the KVM switch system that will be used
thoroughly before installation is completed.
Installing the Hard Drives
MAXX-2400HD uses twelve 1-TB drives in its 12 Terabyte RAID 6 array. These are packaged
in a separate carton inside the main carton. The drives are fully configured and ready to run the
MAXX-2400HD application. It is important that the drives be installed in the correct positions in
the RAID array. Each drive has a number affixed to its packaging material. Install each drive in the
corresponding numbered bay according to Figure 1.
Open the drive bay door by loosening the knurled screws and pulling lightly forward and down.
Install each hard drive in the corresponding numbered slot as follows:
1. Open the blue locking lever by pulling forward slightly
2. Insert the drive in the bay by sliding it in till you feel it “seat”
3. Close the locking lever.
Figure 1 - Drive Bay Organization