Filter
Top Products
40
Mark Levinson
Can’t Assign in ML Net
You must assign the slave from the master device. Verify that the
slave you want to assign is listed in the master device list and check
its current state.
If the current state is assigned, you must first unassign it from the
ML Net system. Once a slave is assigned, it will not accept another
assignment until it has first been unassigned. Once the device is
unassigned, you can then reassign it to the desired ML Net system.
For further explanations on assigning slave devices, refer to the
owner’s manual of the master device.
No Response to
Commands in ML Net
1. Verify that the master device and the Nº512 are properly
connected together with a router.
2. Verify that the Nº512 network setup is correct. A PC-compatible
computer is required to access the internal Web page of the
Nº512 to verify its network settings. Refer to the “Network
Setup” section found earlier in this manual for more details.
No Connectivity Via
Ethernet
1. Verify all network cables are properly connected between the
router, switch, or hub and the Nº512. Verify that the computer
network cable is in the correct port.
2. Verify that the Nº512 network setup is correct. A PC-compatible
computer is required to access the internal Web page of the
Nº512 to verify its network settings. Refer to the “Network
Setup” section found earlier in this manual for more details.
3. Verify the age of the router, switch, or hub. If the router, switch,
or hub is more than ten years old, a communication issue with
the Nº512 may exist. Power cycle the Nº512 and use a newer
router, switch, or hub between the network and the Nº512.
Router Can’t Find the
Device Name
If you can’t connect to the internal web page through the device,
then you’ll need to find the device name through the router. The
status page of most routers identify the device names of all located
devices. In some cases, the device name may not be listed but the IP
address that’s assigned to the device is noted. Put this assigned IP
address into the browser address (URL) line and the internal web
page for the device should load.
If you are using ML Net, you can also use the Nº502 to determine
the name of each connected device. Refer to the ML Net section of
the Nº502 Owner’s Manual for further details.
If All Else Fails...
1. Power cycle the Nº512, waiting at least 10 seconds between
powering the Nº512 off and on.
2. Contact an authorized Mark Levinson dealer.