Filter
Top Products
31
Nº512 CD/SACD™ Player
To change the host name of the Nº512:
A. Type the new name into the white box to the right of the
parameter. The new name must be made from the capital
letters, A to Z, and the numbers, 0 to 9. Underscores may also
be used. Only eight characters are allowed.
B. Click the Submit button to save the new value.
8. Type the new host name of the Nº512 into the address line of
the Web browser. The Nº512 Web page loads, reflecting the new
information. Skip this step if you didn’t modify the host name.
When the page loads, observe that the last six characters of the
player’s MAC address are appended to the new host name.
The network connection is now complete.
Setting Up the
Computer
If DHCP is not used, then the computer must be set up, too. Use this
procedure to set up the computer, then continue to the appropriate
section to connect to the Nº512 player.
For the computer to find the Nº512, the TCP/IP (Internet Protocol)
and LAN (Local Area Network) settings of the computer must be set
up. The parameter setups vary slightly depending upon the
operating system of the computer. Refer to the procedure below
that matches the operating system on your computer.
Note Due to your preference settings in the Windows operating system, the
names and order of the dialog boxes may vary slightly from these
instructions.
Network Setup for Windows XP
1. From the Start menu, select Control Panel.
2. Double-click on the Network Connections option.
3. Double-click on the Local Area Connection option.
4. Click the Properties button to open the Local Area Connection
Properties menu.
Note If the computer is not currently connected to an active network, Step 3
has already opened the Local Area Connection Properties menu.
5. Click on the Internet Protocol (TCP/IP) line item so that it is
highlighted.
6. Click the Properties button.