35
Nº512 CD/SACD™ Player
Direct Connection
If you are not using a router, use this procedure to connect directly
to a computer. For the computer to find the Nº512, the TCP/IP and
LAN settings of the computer must be set up. Refer to the previous
“Setting up the Computer” section for instructions.
Connect one Nº512 player to the computer, as described in the
previous “Connecting the Cables” section. Make sure that both the
player and the computer are powered off before connecting.
1. Press the Power button on the Nº512.
2. On the computer, open the Internet Explorer Web browser.
3. On the address line (URL), type the static IP address of the
Nº512 (192.168.50.8 is the default) and press the Enter button.
There may be a short delay before the Nº512 Web page loads.
4. The Home tab of the Nº512 internal Web page is now displayed.
The tab is in red text to indicate that it is the current page. The
top of the page provides the general status of the Nº512. The
bottom of the page contains the network parameters setup.
5. Observe that the Status section of the Web page identifies the
host name of the Nº512 player. The host name can be modified,
but only the first eight characters are affected; anything after
the underscore may not be modified.
To change the host name of the Nº512:
A. Type the new name into the white box to the right of the
parameter. The new name must be made from the capital
letters, A to Z, and the numbers, 0 to 9. Underscores may also
be used. Only eight characters are allowed.
B. Click the Submit button to save the new value.
C. Click the Refresh button in the Status section of the Web
page to observe the new host name.
6. Observe that the Status section of the Web page also identifies
the IP address of the Nº512 player. The static IP address can be
modified, if desired.
To change the IP address of the Nº512:
A. Type the new IP address into the white box to the right of the
parameter.
B. Click the Submit button to save the new value.
C. Enter the new IP address of the Nº512 into the browser. The
Nº512 Web page loads, reflecting the new information.
The network connection is now complete.