FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution!
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.
For customer service and product
shipment information, refer to the
www.marklevinson.com Web site.
Part No. 070-19027| Rev 0 |06/08
Mark Levinson and the Mark Levinson logo are trademarks of Harman
International Industries, Incorporated, in the United States and/or other
countries.
SACD is a trademark of Sony Corporation.
Microsoft, Internet Explorer and Windows are registered trademarks of
Microsoft Corporation in the United States and/or other countries.
©2008 Harman International Industries, Incorporated. All rights reserved.
This document should not be construed as a commitment on the part of
Harman International Industries, Incorporated. The information it contains is
subject to change without notice. Harman International Industries,
Incorporated, assumes no responsibility for errors that may appear within this
document.