Filter
Top Products
29
ENGLISH
SYMPTOM
Can not select CS
II
mode.
No output to Sub Woofer Out.
Noise is produced during DTS-
encoded CD or laser disc play.
A specific channel does not
produce output.
FM or AM reception fails.
Noise is heard during AM
reception.
Noise is heard during FM
reception.
Cannot get programmed
station when the PRESET
button is pressed.
Control with the remote control
unit fails.
CAUSE
Input signal is incompatible.
Sub-woofer = NONE has been selected
in SETUP mode.
Analog has been selected for input.
Nothing recorded on source.
Antenna connection is incomplete.
Reception is affected by other electrical
fields.
The radio waves from the broadcasting
station are weak.
Preset data has been erased.
Batteries are consumed.
Remote controller's function-key
setting is wrong.
The distance between this SR4400 and
the remote commander is too far.
Something is blocking SR4400 and the
remote commander.
REMEDY
Use PCM input signal or analog input signal.
Select Sub-woofer = YES.
Be sure to perform digital connection, select digital
input, then play.
Check the encoded channel on the source side.
Correctly connect the indoor FM and AM antennas
to FM and AM antenna outlets.
Try changing location where the AM indoor
antenna is set up.
Install an FM outdoor antenna.
Disconnecting power plug for long periods of time
will erase preset data. If that happens, input the
preset data again.
Replace all the batteries with new ones.
Select different position from which equipment will
be controlled.
Move closer to this SR4400.
Remove offending object.
GENERAL MALFUNCTION
If the equipment malfunctions, this may be
because an electrostatic discharge or AC line
interference has corrupted the information in the
equipment memory circuits. Therefore:
- disconnect the plug from the AC line supply
- after waiting at least three minutes, reconnect
the plug to the AC line supply
- re-attempt to operate the equipment
HOW TO RESET THE UNIT
Should the operation or display seem to be
abnormal, reset the unit with the following
procedure.
The SR4400 is turned on, press and hold the
CLEAR and MEMORY buttons simultaneously for
3 seconds or more.
Remember that the procedure will reset the
settings of the function selector, Surround mode,
delay time, TUNER PRESET etc., to their initial
settings.
Memory backup
• In case a power outage occurs or the power
cord is accidentally unplugged, the SR4400
is equipped with a backup function to prevent
memory data such as the preset memory
from being erased.
CLEAR
F/P
MODE
TUNING/PRESET
MEMORY
PHONES
SURROUND
STANDBY
POWER ON/STANDBY
MUTE
S-DIRECT
HT-EQ
DSS/VCR2
DVD
CDR/MD
TAPE
CD
TUNER
TV
A/D
DISPLAY
VCR1
UP
VOLUME
DOWN
AV SURROUND RECEIVER SR4400
CH-IN
6.1
AV SURROUND RECEIVER SR4400
CH-IN
6.1
CLEAR
MEMORY
03.4.10, 3:01 PMPage 29