Filter
Top Products
User Guide
53
Frequently Asked Questions
800kb of memory by using the REVERT feature.
By using REVERT, you will delete the majority of Marantz RC
codes and all of the pre-programmed example macros. The
template files that remain after you revert will allow you to program
any system by customizing the templates and teaching RC codes
to the relabled template buttons (see page 57).
WARNING Should you use the REVERT button, the only way to recover
the factory configuration is by using RC5000 Setup and a
Windows PC.
Procedure for reverting to the memory saving REVERT file:
1 Touch and hold the RC5000i icon for a few seconds.
The first setup panel appears.
2 Scroll to the second setup panel.
3 Tap the Revert button.
4 Tap Revert to confirm the action.
Note The REVERT button is not active until at least one change is
made to the configuration (a label, a delay in a macro or one
new code has been learned). Should the button be greyed out,
make a change to the configuration and then use revert.
How do I calibrate the touchscreen?
The RC5000i is calibrated when it leaves the factory, so normally
you do not have to calibrate it yourself. It is possible that the
RC5000i displays a message to calibrate the touchscreen. If this
message appears do the following.
You will see the instruction “Touch TOP LEFT corner.”
1 Tap as close as possible the upper left corner using a blunt tip
of a pencil.
You will see the instruction “Touch BOTTOM RIGHT corner.”
2 Tap as close as possible the bottom right corner using a blunt tip
of a pencil.