Marantz RC5000i Home Theater System User Manual


 
User Guide
29
Reference
buttons, Device menu items and Direct Access buttons.
You cannot program Home menu buttons directly. You have to
program them via the Device menu (see page 30).
The RC5000i also offers empty control panel buttons which you
can program and label as existing buttons. They are only visible
in Learn and Label mode and appear without label or with label
(intended for a specific function). You will also see previously
deleted buttons: you can restore them by reprogramming them
or you can reuse them for other commands.
Programming Device Panel Buttons
1 Navigate to the Device panel buttons you want to program.
2 Switch to Learn mode via the Mode button .
Additional empty buttons appear, which can be programmed
and labeled as existing buttons.
3 Point the device’s original remote control to the RC5000i’s
learning eye as shown on page 28.
4 Tap the RC5000i button you want to program.
The button starts flashing.
5 Press and hold the corresponding button on your device’s
original remote control.
If the RC5000i has learned the command successfully, OK
flashes on the RC5000i icon. You can let go of the button you’re
holding.
If the RC5000i has not learned the command successfully, you
hear a short buzz and FAIL appears on the RC5000i icon.
6 Program all other buttons you want and relabel them if
necessary (see page 32-34).
7 Return to Use mode via the Mode button.