Marantz RC5000i Home Theater System User Manual


 
7 Switch back to DEL mode and delete the group if it is not a
good match to your component. Repeat steps 4 through 6 until
all of your remote controls have a matching device group.
8 Switch to LABEL mode to relabel each device group (see page
32-34).
9 Switch to MOVE mode to re-order your devices, so that your
home panel is arranged the way you want (see page 39-40).
10 Switch to LABEL mode to personalize the greeting on your
home panel (see page 32-34).
11 Still in LABEL mode, navigate to the DEVICE side of the
RC5000i. Relabel any buttons as needed to match your existing
remote controls. Check all of your devices.
12 Switch to LEARN mode and teach the RC5000i all of your non-
Marantz components’ RC Codes (see page 28-32).
13 Switching back and forth between USE and LEARN modes, test
all codes and reteach as necessary.
Note Should you need to delete a command, use the DEL mode. Be
very careful to NEVER delete the navigational tabs; they can
only be restored with a personal computer (see page 52).
14 Switch back to LEARN mode. Teach each Device group the
appropriate Preamp/Receiver Input (source switching) RC
command (see page 30).
15 Congratulations, you have completed the first stage of
customization! Take a well deserved break.
User Guide
19
Customizing Your RC5000i