Filter
Top Products
THX SETUP Menu
Default Setting Default SettingPossible Settings Possible Settings
CUSTOM SETUP Menu
Parameter
SETUP
MC-12
3-25
Speaker Setup Parameters
THX SETUPSET CROSSOVERSSPEAKERSSETUP
OR
CUSTOM SETUPSET CROSSOVERSSPEAKERSSETUP
The table below indicates the speaker setup parameters that can be
used to configure the Main Zone audio output connectors for the
desired speaker setup. These parameters are available on the
CUSTOM and THX SETUP menus.
Speaker setup parameters perform the same function regardless of
which speaker setup is selected. When a parameter setting is
adjusted on one menu, the corresponding parameter setting is
automatically adjusted on the other menu. For instance, when a
THX speaker setup is selected, the speaker setup parameters on the
CUSTOM SETUP menu are also set to THX 80Hz.
FRONT L/R*
CENTER*
SIDE L/R*
REAR L/R
SUB L/R*
SUB XOVER*
LFE*
ULTRA2 SUB
BGC
ASA
40Hz
THX 80Hz THX 80Hz
THX 80Hz
THX 80Hz
THX 80Hz
THX 80Hz, NONE
THX 80Hz
THX 80Hz
THX 80Hz
MONO MONO
THX 80Hz
60Hz
60Hz
60Hz
MONO
ON ON
OFF OFF
N/A† N/A†
APART APART
40Hz
FULL, 30 to 120Hz, THX 80Hz
FULL, 30 to 120Hz, THX 80Hz
ON, OFF ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
APART, CLOSE, TOGETHER APART, CLOSE, TOGETHER
FULL, 30 to 120Hz, THX 80Hz, NONE
FULL, 30 to 120Hz, THX 80Hz, NONE
FULL, 30 to 120Hz, THX 80Hz, NONE
MONO, STEREO, NONE
* These parameters cannot be adjusted on the THX SETUP menu.
† When the ULTRA2 SUB parameter is set to OFF, the BGC parameter is not available (N/A). . . . Setting Crossover Points continues on page 3-26