Filter
Top Products
Basic Operation
Lexicon
2-20
Two-Line Status (continued from page 2-19)
Record Zone Two-Line Status
Opens on the on-screen and front panel
displays whenever the MC-12 detects a
Record Zone status change. The Record Zone
two-line status indicates the current input, input source, and
volume level selected in the Record Zone.
The ON-SCREEN DISPLAY menu STATUS parameter can be used to
control the length of time for which the two-line status appears on
the on-screen and front panel displays. The ON-SCREEN DISPLAY
menu POSITION parameter can be used to control the vertical
alignment of the two-line status on the display device screen.
Note:
On-screen display menus – including the two-line
status – will not appear on the display device screen
when the display device is connected to the
component video output connector and the MAIN
ADV menu COMPONENT OSD parameter is set to
OFF.
STATUS MENUS
When the Shift command bank is activated, pressing the remote
control STAT button opens the status menu for the current input
source. Status menus are available for 2-channel, Dolby Digital,
dts(-ES), analog, and digital sources. All status menus are shown at
the top of the next page.
Status menu parameters provide information about the current
input source and listening mode. Some status menus also include
level meters that indicate fluctuating audio input levels. Refer to
page 2-24 for status menu parameter descriptions.
Note:
Status menu parameters provide information about
the current input source and listening mode. These
parameters cannot be adjusted.
Unlike most other menus, status menus cannot be opened through
the selection of menu options. Rather, the remote control
command sequence outlined below must be used.
To open and navigate the status menu for the current input
source:
1. Press and release the remote control SHIFT button to activate
the Shift command bank.
2. Press and release the remote control STAT button. The first
page of the status menu for the current input source will open
on the on-screen and front panel displays. If the status menu
includes a second page, the PG1 indicator appears in the top-
right corner of the menu. Press the STAT button again to open
the second page. If the status menu does not include a second
DVD1 %!D VOL
RECORD -34dB