Filter
Top Products
Appendix C Lexicon
C-8
PROGRAMMING THE FUNCTION BUTTONS
To program the Function Buttons:
1. Go to the SETUP mode by pressing both the HOME and ENT
buttons simultaneously for three seconds.
2. Press the LEARN button next to the LCD screen.
3. Select the DEVICE that contains the function button you wish to
program.
4. Press the PAGE button to go to page 2 of the device if necessary.
5. Place the original remote control head to head with the RV-8
remote about 2 inches apart on a flat surface.
6. Press the button on the RV-8 remote you wish to program. Only
the three HOME, PAGE and FAV buttons cannot be programmed.
It is not recommended that you re-program the Main, Zone 2 or
Zone 3 buttons.
7. Press the button on the original remote control that you wish to
program onto the RV-8 remote. Once the RV-8 remote has
received the signal, the RV-8 remote will flash “GOOD” on the
LCD screen, indicating it learned the code correctly. (Perform Step
6 within 20 seconds of step 5; otherwise the remote will revert to
the SETUP menu, and then after a period of time, it will go back to
the MAIN device page.) If it flashes “Fail,” repeat from step 4 until
it learns successfully.
8. Repeat from step 3 until you have programmed all of the buttons
that are required.
9. Once you complete the programming and wish to exit the
LEARNING mode, press the HOME button. Exit from the SETUP
mode by pressing the HOME button again.
If you are having problems learning to the Volume, Channel and
Transport buttons, it may be because you have previously assigned a
“Punch Through” from another device to that device. To remove a
Punch Through, just “punch through” the device to itself. For
example, to erase a punch through from a TV to a SAT device, just
“punch” through the TV to the TV.
See “Programming “Punch Through” Functions” on page 12 for more
information.
PROGRAMMING THE TEN DEVICE BUTTONS
This procedure will program ONE learned code onto the Device
button, so that when that Device is selected, it will send out the
learned signal as it changes to that Device's function pages.
To program the one learned code onto the Device button:
1. Go to the SETUP mode by pressing both the HOME and ENT
buttons simultaneously for three seconds.
2. Press the LEARN button next to the LCD screen.
3. Important: Press the PAGE button.
4. Place the original remote control head-to-head with the RV-8
remote about 2 inches apart on a flat surface.
5. Select any of the 10 device buttons to program onto the RV-8
remote. Press the button on the original remote control to
program into the Device button chosen on the RV-8 remote. Once
the RV-8 remote hasreceived the signal, the RV-8 remote will flash
“GOOD” on the LCD screen, indicating it learned the code
correctly. If it flashes ”FAIL,” repeat from step 4 until it learns
successfully. (Make sure to enter the code signal within 20 seconds
of programming.)
6. Return to step 5 until all Device buttons have been programmed.
7. When done programming, press the HOME button to exit the
Learning mode. Exit from the SETUP mode by pressing the HOME
button once again.