Filter
Top Products
Mode Adjust Lexicon
6-10
DTS NEO:6 + THX
This mode is designed for playback of matrix-encoded digital stereo
film sources. DTS Neo:6 derives six channels when both side and rear
speakers are present (rear channels will be in parallel). It derives five
channels when only side or rear speakers are present.
In addition to THX processing, THX re-equalization is applied to
simulate high-frequency rolloffs that occur in movie theaters. Most
films are mixed for movie theaters, and may sound too bright when
played back in home theaters without re-equalization.
This listening mode is a dynamic listening mode and cannot be
assigned as a preferred listening mode. To select this listening mode
use the remote control or front-panel Mode button. When the
2-CH parameter is set to USE LAST, the RV-8 will automatically
activate a DTS Neo:6 + THX listening mode if this mode was
activated the last time a 2-channel source was present.
See “Listening Mode Menu Option and Parameter Descriptions” on page 6-39 for
detailed descriptions
.
DTS NEO:6 CIN & DTS NEO:6 MUSIC
These modes are designed for playback of matrix-encoded digital
stereo film or music sources. DTS Neo:6 derives six channels when
both side and rear speakers are present (rear channels will be in
parallel). It derives five channels when only side or rear speakers are
present.
These listening modes are dynamic listening modes and cannot be
assigned as preferred listening modes. To select either of these
listening modes, use the remote control or front-panel Mode
button. When the 2-CH parameter is set to USE LAST, the RV-8 will
automatically activate a DTS Neo:6 listening mode if this mode was
activated the last time a 2-channel source was present.
Note:
• The RV-8 will not automatically activate a DTS NEO:6 listening
mode unless a 44.1kHz or 48kHz PCM digital source is present.
The DTS Neo:6 listening modes are not available with 88.2kHz or
96kHz, Dolby Digital or analog sources.
• The DTS Neo:6 MUSIC listening mode can be activated with the
front-panel or remote control Mode buttons. The DTS Neo:6 CIN
listening mode can also activated with the remote control DTS
button when a 2-channel input source is present.
See “Listening Mode Menu Option and Parameter Descriptions” on page 6-39 for
detailed descriptions
.
Parameter Default Setting Possible Settings
RE-EQUALIZER ON ON, OFF
OUTPUT LEVELS Refer to page 6-37
CUSTOM Refer to page 6-37
MODE ADJUST
+
Parameter
OUTPUT LEVELS Refer to page 6-37
CUSTOM Refer to page 6-37
MODE ADJUST
CIN MUSIC
OR