Filter
Top Products
52
EN
Preparations
Basic section
Application section
Knowledge section
1
Select PGM mode.
Press the P.MODE key on the remote control
unit.
3
Start playback.
Select the DVD/CD input.
1Select the track number with the Numeric
keys on the remote control unit.
2Press the SET key to confirm the selection.
(To select more than one track, repeat steps 1 and
2 for each track.)
Various disc playback features
Press the key in
the stop mode.
Listening to the desired sequence
(program playback)
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
L
R
30 10 5 3 1 0
(-dB)
PGM
12345
L
R
30 10 5 3 1 0
(-dB)
PGM
12345
Press the Numeric keys as shown below;
To select track No. 23: +10, +10, 3
To select track No. 30: +10, +10, +10, 0
÷ Up to 32 tracks can be programmed. When "PGM
FULL" is displayed, no more tracks can be
programmed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
2
Select track numbers in the order you want to play them.
÷ Tracks will be played in the order they were
programmed (following the program numbers).
÷ When the 4 key is pressed once during playback, the
track being played will be played from the beginning.
To skip further to a track proceeding the current track,
press the 4 key twice repeatedly.
÷ When the ¢ key is pressed during playback, play will
skip to the next track in the program.
The indicator lights up.
*5613/52-57/EN 06.1.6, 0:54 PM52