Filter
Top Products
27
EN
Preparations
Basic section
Application section
Knowledge section
Basic use method
Changing measured Room Equalizer Char-
acteristics according to situation (ROOM
EQ MODE)
1 Press the ROOM EQ MODE key on the re-
mote control unit.
2 Select a mode by using the INPUT SEL./
MULTI CONTROL knob. [press the MULTI
CONTROL @ / # key on the remote. ]
The following mode items can be selected:
"NORMAL":
This mode reproduces the sound
optimized based on the measured
results by ROOM EQ. Usually, use
this mode.
"WIDE": Mode that you can enjoy
music at a relatively wide area cen-
tering around the measured posi-
tion. It is convenient, for example,
when you wish to listen to music
walking around room at a home
party.
"NIGHT": Mode that is convenient when you
wish to enjoy music with low vol-
ume at midnight. It is adjusted
based on melodious sounds such as
vocal and will relatively be clear
sound with low volume.
÷ Press the ENTER key on the remote control to end
the operation.
To cancel the measurement
Turn the VOLUME knob on the main unit or
press the VOLUME % / fi key on the remote
control unit.
or
÷ When the operations of steps 3 and 4 on page 26
are performed and the SET key is pressed after dis-
play of “R. EQ CANCEL?”, measuring is canceled
and return is made to the condition before start.
Memorizing the measurement
(Memorizing your favorite sound
º
)
The ROOM EQ MODE cannot be set
when Auto Room Equalizer measur-
ing has not been performed.
The Auto Room EQ settings can be stored.
It is recommended to store the settings with
the operation shown on page 30
.
*5613/23-38/EN 06.1.6, 0:53 PM27