Filter
Top Products
52
Radio Operations
Hard to hear broadcasts because of noise.
] Antenna connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended and
positioned.
Disc/USB mass storage class device Playback
Operations
The disc does not play.
] You have inserted a disc whose Region Code is not
correct. (“REGION ERR” appears on the display.)
] The disc is placed upside down. Place the disc with
the label side facing up.
ID3 Tag on an MP3 file cannot be shown.
] There are two types of ID3 Tag—Version 1 and
Version 2. This System can only show ID3 Tag
Version 1.
Groups and tracks are not played back as you expect.
] The playing order is determined when the groups
and tracks were recorded. It depends on the
writing application.
MP3, WMA, WAV, JPEG, MPEG-1, MPEG-2, ASF or DivX
files are not played back.
] The disc or the USB mass storage class device may
contain different types of files (ex. MP3/WMA/
WAV/JPEG). In this case, you can only play back
the files selected by pressing FILE TYPE (see page
12).
] You have changed the “FILE TYPE” setting
after the System read the disc or the USB mass
storage class device. In this case, reload the disc or
disconnect the USB mass storage class device and
connect it again.
The disc sound is discontinuous.
] The disc is scratched or dirty.
Troubleshooting
General
Adjustments or settings are suddenly canceled
before you finish.
] There is a time limit. Repeat procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction
due to external electrical interference. Unplug the
power cord and then plug it back in.
Unable to operate the System from the remote
control.
] The path between the remote control and the
remote sensor on the System is blocked.
] The batteries are exhausted.
No sound is heard.
] Speaker connections are incorrect or loose.
] Headphones are connected.
No picture appears on the TV screen.
] The video cord connections are incorrect or loose.
No picture is displayed on the TV screen, the picture
is blurred, or the picture is divided into two parts.
] The System is connected to a TV which does not
support progressive video input.
] Incorrect scanning mode is selected (see page 7).
] When you unplug the power cord and plug it back
again, the scanning mode may change back to the
initial setting (see page 7).
The left and right edges of the picture are missing
on the screen.
] Select “4:3 LB/4:3 MULTI LB” for “MONITOR
TYPE” (see page 45).
text_EN_NXG7G3.indb 52text_EN_NXG7G3.indb 52 08.7.14 11:42:28 AM08.7.14 11:42:28 AM