Filter
Top Products
CHAPTER 1 – Introduction
SYS7180VE User’s Manual
5
1.6 Block Diagram
PCI TO ISA
Bridge
W83629D
W83629D
GIGA LAN
Connector
ICH4
Processor
PWM
PICMG PCI/ISA SLOT
VGA CRT
CONNECTOR
SOCKET 478
P4 PROCESSOR
AC'97
CODEC
CTRL
DATA
IDE Secondary
GMCH
COM1
Floppy
COM2
AC'97 LINK
DDR 266 Mhz
RAID Secondary IDE
IDE Primary
Modules
FirmWare Hub
LAN 10/100
RJ45-Connector
W83627HF
Audio
Connector
DDR266
RS232 /
422 /
485
DATA
PHY
82562EM
UDMA66/100
USB I/F
CTRL
Keyboard
LPC
SUPER-I/O
BROOKDALE-G
RAID IDE
CONTROLLER
PDC20265R
RAID Primary IDE
CLOCK
ICS950220
AGTL+ BUS
ADDR
Mouse
ADDR
USB 2.0
PORT 1-6
GIGA LAN
CONTROLLER
82540
LPC INTERFACE
Parallel
PCI CNTRL + PCI ADDR/DATA
RS232
FCBGA760
IrDA
CHAPTER 2 –Hardware Installations
6
SYS7180VE User’s Manual
Chapter 2 Hardware Installations
This chapter provides information on how to use the jumpers and connectors on
the SYS7180VE in order to set up a workable system.
2.1 Installation procedure
2.1.1 Insert the system BIOS (if not already installed) genteelly. Pay attention to
the position of pin 1 of BIOS socket.
2.1.2 Install the processor with correct orientation.
2.1.3 Insert the DRAM module with correct orientation.
2.1.4 Mount the Fan on the top of the processor and connect it to FAN connector.
2.1.5 Insert all external cables except for flat panel. (Hard disk, floppy, keyboard,
Mouse, LAN, etc.)
2.1.6 Prepare a CRT monitor for CMOS setup.
2.1.7 Confirm the power supply is off.
2.1.8 Turn on the power.
Note: The CMOS memory may be in an undefined state at power-on after a period of no
battery backup.