26 Intel Blade Server Fibre Channel Switch Module SBCEFCSW / FC Expansion Card SBFCM Guide
Set Config command
Sets port, switch, alarm threshold, and zoning configuration parameters.
Authority
Admin authority and a Config Edit session. See the “Config command” on page 10 for information about
starting a Config Edit session.
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port number]
Initiates an editing session in which to change configuration parameters for the port number given by
[port_number]. If you omit [port_number], the Blade Server Chassis SBCE begins with port 0 and
proceeds in order through port 15. For each parameter, enter a new value or press the Enter key to
accept the current value shown in brackets. Type q to cancel the configuration for one port, or qq to
cancel the configuration for all ports. Table 7 on page 26 describes the port parameters.
✏ NOTE
For external ports (0,15), all port parameters apply. For internal ports, only the port state
setting is configurable. For information about port numbering and mapping, see Table 37 on
page 124.
port [port number]
Initiates an editing session in which to change configuration parameters for the port number given by
[port_number]. If you omit [port_number], the Blade Server Chassis SBCE begins with port 0 and
proceeds in order through port 15. For each parameter, enter a new value or press the Enter key to
accept the current value shown in brackets. Type q to cancel the configuration for one port, or qq to
cancel the configuration for all ports. Table 7 on page 26 describes the port parameters.
✏ NOTE
For external ports (0,15), all port parameters apply. For internal ports, only the port state
setting is configurable. For information about port numbering and mapping, see Table 37 on
page 124.
ports [port number]
Initiates an editing session in which to change configuration parameters for all ports based on the
configuration for the port given by [port_number]. If you omit [port_number], port 0 is used. For each
parameter, enter a new value or press the Enter key to accept the current value shown in brackets.
Type q to cancel the configuration. Table 7 on page 26 describes the port parameters. For external
ports (0,15), all parameters apply. For internal ports (1 through 14) only AdminState applies.
Table 7. Set Config port parameters
Parameter Description
AdminState Port administrative state: online, offline, diagnostics, or down.
LinkSpeed 1 Gbps or 2 Gbps.
PortType Type of port.