Filter
Top Products
86 Intel Blade Server Fibre Channel Switch Module SBCEFCSW / FC Expansion Card SBFCM Guide
Zone merge failure recovery
When a zone merge failure occurs, the conflict that caused the failure must be resolved. You can correct a
failure due to a zone conflict by deactivating one of the active zone sets or editing the conflicting zones so that
their membership is the same. You can deactivate the active zone set on one switch module if the active zone
set on the other switch accurately defines your zoning needs. If not, you must edit the zone memberships and
reactivate the zone sets. For information about adding and removing zone members, see “Managing zones” on
page 89. To permit the fabrics to join, reset the ports that were isolated. See “Resetting a port” on page 113.
Using the Edit Zoning window
Use the Edit Zoning window to edit the zoning database for a specific switch module. To edit the zoning
database, in the Faceplate window, click Zone / Edit Zoning. The Edit Zoning window opens.
✏ NOTE
You can make changes only to an active zone set, which is stored in flash (nonvolatile) memory and
retained after setting a switch module.
Figure 11. Edit Zoning window
The Edit Zoning window displays a Zone Sets tree in the left pane and a Port and Device (or members) tree in
the right pane, as shown in Figure 11 Both trees use display conventions similar to the fabric tree for
expanding and contracting zone sets, zones, and ports. An expanded port shows the port Fibre Channel
address; an expanded address shows the port worldwide name. You can select zone sets, zones, and ports in the
following ways:
• Click a zone, zone set, or port icon.
• Right-click to select a zone set or zone and open the corresponding pop-up menu.
• Hold down the Shift key while clicking several consecutive icons.
• Hold down the Ctrl key while clicking several nonconsecutive icons.
Using the toolbar, pop-up menus, or a drag-and-drop method, you can create and manage zone sets and zones
in the zoning database. Click Apply to save your changes to the zoning database without closing the window.
Click OK to save your changes to the zoning database and close the window.