Filter
Top Products
136 Intel Blade Swerver Switch Module SBCEFCSW / FC Expansion Card SBFCM: HMM and Troubleshooting Guide
Using Fast!UTIL
This chapter provides detailed configuration information for advanced users who want to customize the
configuration of the Expansion Card. You can configure the expansion card using the Fast!UTIL utility.
Starting Fast!UTIL
Start or restart the blade server. On the blade server control panel, press the keyboard/video/mouse select
button.To access Fast!UTIL, press Ctrl+Q during the expansion card BIOS initialization (it might take a few
seconds for the Fast!UTIL menu to be displayed). The Expansion Card has dual adapter ports that can be
configured separately with Fast!UTIL. After changing the settings that are described in the “Configuration
Settings menu options,” Fast!UTIL restarts the blade server to enable the new parameters.
Important: If the configuration settings are incorrect, the Expansion Card might not function properly.
Configuration Settings menu options
✏ NOTE
For information about Remote Boot options, contact your
Intel technical-support representative.
Use the options described in this section to configure the Expansion Card. The Configuration Settings menu
displays several options that you can use to configure your expansion card.
Select host adapter
Use this option to select, configure, or view either of the two I/O port addresses on the Expansion Card.
Host Adapter Settings
To access this option, select Host Adapter Settings. The default settings and the modifiable settings for the
expansion card are listed in Table <$elemparanumonly and are described in this section. The Expansion Card
is always point-to-point connected in the blade server with the Fibre Channel switch module.
✏ NOTE
The loop reset delay, adapter hard loop ID, and hard loop ID settings are not applicable.
Table 39. Modifiable expansion card default settings
Setting Options Default
Host adapter BIOS Enabled or disabled Disabled
Frame size 512, 1024, 2048 2048
Loop reset delay 0-60 seconds 5 seconds
Adapter hard loop ID Enabled or disabled Enabled
Hard loop ID 0-125 125
Spin up delay Enabled or disabled Disabled