Intel SBFCM Stereo Receiver User Manual


 
126 Intel Blade Swerver Switch Module SBCEFCSW / FC Expansion Card SBFCM: HMM and Troubleshooting Guide
Humidity
Blade server on: 8% to 80%
Blade server off: 5% to 80%
Table 38. Expansion Card specifications
Type Specification
Expansion card bus Supports subset of PCI local bus specification, revision 2.2 and the PCI-
X specification 1.0a
PCI/PCI-X signaling environment Supports 3.3 V only
PCI/PCI-X transfer rate The burst transfer rate is based on the input clock speed multiplied by
the number of bytes (8).
PCI - 66 = 525 MB per second
PCI-X - 100 = 800 MB per second
Fibre Channel specifications Bus transfer rate: 200 MB per second maximum at half-duplex and
400 MB per second maximum at full-duplex
Support for both FCP-SCSI and IP protocols
Support for point-to-point fabric connection: F-Port Fabric Login
Support for FCAL public loop profile: FL-Port Login
Support for Fibre Channel services class 2 and 3
Support for FCP SCSI initiator and target operation
Support for full-duplex operation
Copper interface ac coupled
Processor Single-chip design with two completely independent 2 Gb serial Fibre
Channel ports. Each port provides:
RISC processor
Integrated serializer/deserializer
Receive direct memory access (DMA) sequencer
Frame buffer
Five-channel DMA controller
Host data transfer 64-bit, 100 MHz bus-master DMA data transfers to 800 MB per second
RAM 512 KB sync burst SRAM per channel supporting parity protection
BIOS ROM BIOS ROM 128 KB of flash memory (the flash is field programmable)
NVRAM NVRAM 256 bytes, field programmable
Onboard DMA Five-channel DMA controller for each port: transmit, receive, command,
auto-request, and auto-response
Frame buffer FIFO Integrated 4 KB transmit and 6 KB receive frame buffer FIFO for each
data channel
Connectors (internal only) Board-to-board Molex HSM type for serial interfaces
200 pin board-to-board for PCI-X interface
Dimensions Approximately 9.35 cm x 13.14 cm (3.683 in. x 5.275 in.)
Operating power Less than 12 watts