101
✏ NOTE
The Read Community, Trap Community, and Write Community settings are like passwords;
therefore, they are write-only fields. The current settings are not displayed.
Figure 16. Network Properties window
IP configuration
The IP configuration identifies the switch module on the Ethernet network and determines which start (boot)
method to use. Start methods described in the following table are for external and internal ports. Table 23
describes the IP configuration parameters.
Remote logging
The Remote Logging (syslog) feature enables saving of the log information to a remote host that supports the
syslog protocol. When enabled, the log entries are sent to the syslog host at the IP address that you specify in
the Logging Host IP Address field. Log entries are saved in the internal switch module log whether this
feature is enabled or not.
Table 23. IP configuration parameters
Parameter Description
IP address Internet protocol (IP) address for the Ethernet port.
Note: When the Blade Server Chassis SBCE is turned on, the management module
loads the following factory default Ethernet IP addresses:
• Switch module bay 3: 192.168.70.129
• Switch module bay 4: 192.168.70.130
Subnet mask Subnet mask address for the Ethernet port. The default value is 255.255.255.0.
Boot method Static - Uses the IP configuration parameters entered in the Switch Properties window.
Gateway IP gateway address. The default value is 10.90.90.254.