Filter
Top Products
27
Setup menus
When making the various settings required to configure your DTR-7.2 optimally, you can either use the OSD menu that appears on your
television monitor or you can use the display on the front of the DTR-7.2. The OSD menu is a settings menu that is displayed on your TV
monitor. For use as reference when performing the setting procedures, this manual shows both the OSD menu displayed on your television
monitor and the display on the front of the DTR-7.2.
The Setup menu consists of a main screen that is divided up into 5 menus: Hardware Setup, Speaker Setup, Input Setup, Audio Adjust, and
Preference. These menus are then divided up into various sub-menus, and these contain settings for you to optimize your home theater as you wish.
Button on remote controller Button on DTR-7.2
SETUP
(upper edge of
ENTER button)
(lower edge of
ENTER button)
(left edge of
ENTER button)
(right edge of
ENTER button)
ENTER
RETURN
Setup
UP
DOWN
LEFT
RIGHT
Enter
Return
Advanced Menu
0.Hardware Setup
1.Speaker Setup
2.Input Setup
3.Audio Adjust
4.Preference
|ENTER|Quit:|SETUP|
→
Basic Menu
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
Quit:|SETUP|
|ENTER|Quit:|SETUP|
1-1.Speaker Config
a.Subwoofer :Yes
b.Front :Small
c.Center :Small
d.Surr L/R :Small
e.Surr Back :Small
f.Surr Back Out :1ch
Quit:|SETUP|
Return
Setup
Enter
1. Press the SETUP button.
The main menu screen of the Main menu appears on your TV
monitor.
2. Using the and cursor buttons, select the menu
that you want to enter.
3. Press the ENTER button to enter the selected menu.
The screen for that menu appears.
4. Using the and cursor buttons, select the sub-
menu that you want to enter, and press the ENTER
button.
Each sub-menu has different settings that can be changed as
desired, and they are all explained below. To change a setting,
first select it using the
and cursor buttons, and then change
the setting using the and cursor buttons.
5. Press the RETURN button to set the new settings and
return to the previous menu screen, and again to
return to the main screen.
Note:
Press the SETUP button to exit the Setup menu immediately.
Main menu
Menu
Sub-menu
Navigating through the Setup menu
You can change settings using the buttons on the front panel and on
the remote controller.
The buttons on the remote controller correspond to those on the
DTR-7.2 as shown below.