Filter
Top Products
24
When using the ZONE 2 OUT terminals
The ZONE 2 OUT terminal is a constant output. Connect to the
LINE input of the amplifier (CD, tape, etc.). Adjust the volume
with the amplifier connected to the ZONE 2 OUT terminal.
1. Connect the DTR-7.2 to the amplifier for the remote
zone.
2. Connect the remote zone speaker cables to the
speaker terminals on the amplifier.
Adjust the volume level at the amplifier.
3. Connect the DTR-7.2 to the monitor for the remote
zone.
Connecting the remote zone (Zone 2)
speakers
The DTR-7.2 allows you to connect another set of speakers and
place them in a different room or separated area for listening to
music. This other room or area is referred to as the remote zone
(Zone 2), while the room where the DTR-7.2 is located is the main
zone. In addition, the IR IN/OUT allows you to control the DTR-
7.2 from the remote zone (Zone 2) with the remote controller even
though the remote zone is physically separated. The diagram below
shows how to make the proper connections for the remote zone.
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
OUT
ZONE 2
Remote Zone (Zone 2)
Main Room
Zone 2
Right speaker
Zone 2
Left speaker
Zone 2 amplifier
Left (white)
Right (red)
DTR-7.2
Zone 2 monitor
or projector