Filter
Top Products
86
Zone 2—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Controlling Zone 2 with the Remote
Controller
Note:
• To control Zone 2, you must press the remote control-
ler’s [Zone 2] button first.
5
Press the [Setup] button.
The setup menu closes.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button repeatedly.
Alternatively, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the Zone 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
To select AM or FM press the [Tuner]
input selector button repeatedly.
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Z2 Sel: Source”
appears.
2
To turn off Zone 2, press the
Zone 2 [Off] button.
1 2
1
Press the [Zone 2] button, then
point the remote controller at the
AV receiver and press the
[Standby/On] button.
Zone 2 turns on, and the ZONE 2 12V
TRIGGER OUT goes high (+12 V).
2
To select an input source for
Zone 2, press the [Zone 2] but-
ton, followed by an Input Selector
button.
To select AM or FM press the [Tuner]
Input Selector button repeatedly.
3
To turn off Zone 2, press the
[Zone 2] button, followed by the
[Standby/On] button.
Zone 2
Level –/+
Iuput
Selector
Standby/On