Filter
Top Products
42
First Time Setup—Continued
2
Put the speaker setup micro-
phone at measurement point
(page 41), and connect it to the
Setup Mic jack.
Notes:
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally be
will provide better results. You can
adjust the height of the microphone
by using a tripod or level table.
3
Press [Enter].
The automatic speaker setup starts.
A test tone is output by each speaker in
turn, as the Audyssey 2EQ function
determines which speakers are con-
nected. This takes a few minutes.
Note:
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so don’t make
any noise.
Auto Speaker Setup
AUDYSSEY
Please place microphone at center
of listening area at ear height.
Push Enter : Next
Auto Speaker Setup
AUDYSSEY
Do not unplug microphone.
Please keep quiet.
Now Measuring. . .
4
The speaker detect results
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [ ]/[ ] but-
tons to select Next, and then
press [Enter].
The options are:
Next:
Proceed to the next step.
Retry:
Return to step 2 and try again.
Cancel:
Cancel the automatic speaker setup.
5
The following screen appears.
Move the speaker setup micro-
phone to measurement point
(page 41), then press [Enter].
Audyssey 2EQ performs more mea-
surements. This takes a few minutes.
Auto Speaker Setup
- - - - - SP Detect Result - - - - -
AUDYSSEY
Cancel
Retry
Next
: Yes
: Yes
: Yes
:No
: Yes
: Yes
: Yes
: Yes
FL
SL
SBL
C
FR
SR
SBR
SW
Auto Speaker Setup
AUDYSSEY
Please place microphone at right end
of listening area at ear height.
Push Enter : Next