Filter
Top Products
45
First Time Setup—Continued
Reviewing the Results Changing the Speaker Settings Manually
In some situations, the measurements taken by the auto-
matic speaker setup may not provide usable results. If
running the speaker setup a second time still doesn’t pro-
vide usable results, you’ll have to set the speaker settings
manually (see pages 68–73).
Using a Powered Subwoofer
If you’re using a powered subwoofer, because it outputs
very low-frequency sound and its position is usually low,
it may not be detected by the automatic speaker setup. If
the subwoofer (SW) appears on the SP Detect Result
screen as “No,” increase the subwoofer’s volume to the
half-way point, set it to its highest crossover frequency,
and then try running the automatic speaker setup again.
Note that if the volume is set too high and the sound dis-
torts, it may not be detected, so use an appropriate vol-
ume level. If the subwoofer has a low-pass filter switch,
set it to Off or Direct. Refer to your subwoofer’s instruc-
tion manual for details.
Use the Up and Down [ ]/[ ]
buttons to select the settings that
you want to review, and then
press [Enter].
The options are:
Review SP Config:
Review the speaker configuration
settings.
Review SP Distance:
Review the speaker distance set-
tings.
Review SP Level:
Review the speaker level settings.
Press the [Return] button to return to
the previous menu.
Save
Review SP Config
Review SP Distance
Review SP Level
Cancel
Auto Speaker Setup
AUDYSSEY
Review SP Config
Subwoofer : Yes
Front : Full Band
Center : 80Hz
Surround : 100Hz
Surr Back : 150Hz
Surr Back Ch : 2ch
Auto Speaker Setup
AUDYSSEY
Review SP Distance
Front : 15.0ft
Center : 15.0ft
Surr Right : 7.0ft
Surr Back R : 7.0ft
Surr Back L : 7.0ft
Surr Left : 7.0ft
Subwoofer : 15.0ft
Auto Speaker Setup
AUDYSSEY
Auto Speaker Setup
AUDYSSEY
Review SP Level
Left : +12.0dB
Center : 0.0dB
Right : -12.0dB
Surr Right : +3.0dB
Surr Back R : +4.0dB
Surr Back L : -6.0dB
Surr Left : -3.0dB
Subwoofer : 0.0dB